One kit.Every socket.
A natural-fiber lamination sleeve engineered for prosthetic fabricators. Drop-in for fiberglass and carbon — without the itch, the waste, or the fixed-size guesswork.
No itch, no glass grit
Bast fiber lays up clean. No airborne glass, no skin irritation for you or your tech.
Heat-gun adjustable after cure
Fine-tune fit post-lamination with a standard heat gun. No re-cast, no re-lam.
One SKU covers every patient
Segments stretch from 10″×36″ to 5″×84″ — trans-radial through trans-femoral.
Flat $11.99 shipping
In stock. Same-week dispatch to certified fabricators across the US.
X1Fiber Kit
5 segments · 1 kit
$200
- 5 woven natural-fiber segments (15–35 ft of usable material)
- Adjustable 10″×36″ → 5″×84″ per segment
- Cut chart + spec sheet included
- Compatible with standard lamination resin
- Subtotal
- $200
- Shipping
- $11.99
- Total
- $211.99
Secure checkout
One kit. Up to 35 feet of usable material.
Each kit ships with 5 segments. Leave them wide and short, or stretch them narrow and long. Either way, you get more coverage than a fixed-width roll.
Per segment · 5 segments
Per segment · 5 segments
A typical fixed-width sleeve gives you one length and one width. X1Fiber gives you both: keep the full width for large sockets, or stretch the same segments for longer, narrower layups. One SKU covers more patients and leaves less waste on the bench.
How to lay it up
Under 250 lb
4 segments · 8 layers. Two-stage lamination: 4 layers per stage.
Lightweight / dynamic
Minimum 3 segments · 6 layers total.
Over 250 lb
5+ segments with reinforcement at distal end, connection points, M/L, A/P.
Bast fiber absorbs resin uniformly — don't over-stretch the sleeve or under-saturate the layup. Optional reinforcement (fiberglass, aramid, carbon) at strategic points is supported; keep synthetic reinforcements away from trim lines. After cure, a standard heat gun softens the matrix for on-the-spot fit adjustments — no re-cast, no re-lamination.
Recommended codes
L5940
Addition, endoskeletal system, below knee, ultra-light material (titanium, carbon fiber or equal)
L5950
Addition, endoskeletal system, above knee, ultra-light material (titanium, carbon fiber or equal)
L7400
Addition to upper extremity prosthesis, below elbow / wrist disarticulation, ultra light material (titanium, carbon fiber or equal)
L2755
Addition to lower extremity orthosis, high strength, light weight material, all hybrid lamination / prepreg composite, per segment, for custom fabricated orthosis only
The listing of codes with our products should not be construed as a guarantee for coverage and/or payment. The ultimate responsibility for the coding of services/products rests with the individual practitioner.